Page 1 of 1

Little Dot MK III SE

Posted: Feb 21st, '17, 07:25
by sword_yang
Little Dot MK III SE is a hybrid and fully balanced amplifier, you can think of it as the ultimate upgrade for MK III series.It uses 6N11 as its preamp tubes(6922/ECC88,etc.) Transistor part runs on a fully discrete, fully symmetry, and pure class A circuit design. The amp is balanced and it has 3 pin XLR balanced input and 4-pin XLR output, and it also has a RCA input, 6.35 output. Very delicate two layer oxidation on chassis, and a gold-plated tube rack.
Image

Image

Image

Image

Image

Image

Image

Image

The input terminals
  • Balance: XLR 3 pins x2
  • Ubalance: RCA x2

The output terminal
  • Balance: XLR 4 pins x1
  • Ubalance: 6.35 mm x1

Technical Specifications
  • Input impedance:10K Ω
  • Distortion degree:0.001%(1000 Hz)(output: 2v RMS)
  • SNR:95dB
  • Frequency response:5 hz-100 KHZ(1 dB)
  • Output power:
    2.5W (32 Ω)
    1.8W (120 Ω)
    0.8W (300 Ω)
  • Adapter headphone impedance:32 ohm-600 ohm
  • Magnification:
    Gain = HIGH:9
    Gain = LOW:4.5
  • The power consumption:30 VA